Holfuy Support: How to upgrade your station with a pressure sensor

How to upgrade your station with a pressure sensor

Please follow the steps in this guide if you have bought a new pressure sensor from Holfuy for your weather station.

Tools required:

Steps:

Open the station's enclosure.
Turn off your station.
Plug in the pressure sensor to the main board's 4 pin pressure sensor socket.
Orientation: the longer part of the sensor board should be away from the green wire terminal.
Contact us to set the right sensor configuration for your station. Without it your new sensor may not work properly.
Turn on your station.
Close the station's enclosure with extra care on the proper sealing.
Please don't forget to plug in the solar cell's red T-connector into the main board.