How to upgrade your station with a pressure sensor
Please follow the steps in this guide if you have bought a new pressure sensor from Holfuy for your weather station.
Tools required:
-
Cross/Phillips (+) screwdriver
Steps:
- Open the station's enclosure.
- Turn off your station.
-
Plug in the pressure sensor to the main board's 4 pin pressure sensor socket. Orientation: the longer part of the sensor board should be away from the green wire terminal.
- Contact us to set the right sensor configuration for your station. Without it your new sensor may not work properly.
- Turn on your station.
-
Close the station's enclosure with extra care on the proper sealing. Please don't forget to plug in the solar cell's red T-connector into the main board.
< Back to other topics
